Scott Aerator DA-20 Aerating Pond Fountain

We recommend using a minimum of 1 HP for each acre of pond size, this will provide adequate aeration. For a truly spectacular display, it's well worth it to go with the largest motor you can!

This depends on the power set-up that you have. 115V motors will plug into any standard residential outlet, while 230V motors are hardwired directly to a panel. As a general rule of thumb: If your main breaker panel is further than 50 feet from the pond, then you should use 230V to ensure the fountain works properly. If the main breaker panel is too far away from the pond and you try to use 115V, the motor will be starved of power and spray weak or shut off immediately.

If you do not already have power near your pond, then you'll want to consult a licensed electrician to install a power source. Once a power source is available, installation of the fountain is relatively easy. The fountain floats in the middle of the pond and is anchored on two sides using nylon rope and cinder blocks (for bottom anchoring) or ground stakes (for shore anchoring). Once anchoring is complete, the fountain is then plugged in via submersible cord to the power source at the edge of your pond.

If you're adding a fountain for aeration, we advise running it for a minimum of 12 hours per day. If it's purely for decoration, then you can run it as long as you'd like.

Scott Aerator fountains are designed to be completely winter safe and should be left in the pond year-round. Before temperatures dip below freezing you can either disconnect the power and let the fountain freeze in place, or run it 24/7 to prevent ice from forming around the motor.

Generally, you should not have to clean the fountain often. The fountain is equipped with a stainless steel debris shield which does a great job at preventing clogs. If you notice a drop in spray size over time, that's a sign the fountain needs to be cleaned. Disconnect the power, remove the fountain from the pond and clear out the debris basket.

Fountains do more than just look great, they’re also one of the most effective ways to aerate a pond. Unlike other aeration methods, fountains spray water into the air where it absorbs maximum oxygen before returning to the pond. This process delivers far greater oxygen transfer and surface agitation, helping control mosquitoes, algae, duckweed and improving overall water quality. Because fountains spread oxygen-rich water across the entire surface, they are capable of broader and more consistent coverage. In fact, most State and County agencies specify fountains in their permitting requirements for new retention ponds — a clear sign of their proven effectiveness and reliability.

Scott Aerator light kits easily attach onto the fountain’s float in just minutes using the provided hardware. Each kit includes its own set of power cord which plugs into a standard residential outlet. Both white and colored options come with a timer, and the colored light kits also include a remote control. We recommend using our 2-bulb kits for motors 1 HP or less and our 4-bulb kits for motors 1.5 HP or more.

Fountain pump timers are completely optional. They control the fountain only, so if you plan to have your fountain run on a schedule, adding a timer is a smart move.